Raychem 224W221-25-0 is a 90-degree moulded part with retention lip in fluid resistant modified elastomer. Use this boot where the wiring harness must change direction immediately behind the connector — typical in tight chassis installations where a straight boot would cause the cable to strain against the boot wall. For the same connectors where cable routing permits a straight exit, use 204W221-25-0 instead.
Raychem 224W221-25-0 Specifications
| Property | Value |
|---|---|
| Moulded shape | 90° |
| Lipped | Yes |
| H — Big End diameter, as supplied | 11 mm |
| H — Big End diameter, after recovery | 9.3 mm |
| J — Small End (port) diameter, as supplied | 11 mm |
| J — Small End (port) diameter, after recovery | 2.1 mm |
| P — Total length, after recovery | 12.3 mm |
| R — Height, after recovery | 13 mm |
| Operating temperature | -75 °C to +150 °C |
| Adhesive pre-coat | No |
| Material | Fluid Resistant Modified Elastomer |
Note: this boot is not pre-glued. Apply HellermannTyton V9500 Epoxy for a fully sealed installation.
Compatible Connectors
- Deutsch ASL (MicroLITE) — all shell 6 variants
- Souriau 8STA — shell size 4 to 6
HellermannTyton Alternative
HellermannTyton equivalent: 1181-4-G.
Reviews
There are no reviews yet.